Storing a Scene Cont.
Selecting a memory number and storing the memory:
Editing Midi (Program Change):
Inserting Scenes:
Copying Scenes:
a/ The numbers in the display can be altered as follows. Select either Act or Scene
using the ACT/SCENE C/O switch. You will see either act or scene illuminate
below the display.
b/ The digits can then be altered between 00-99 using the UP and DOWN keys. This
function is looping so if you are on 00 you can go directly to 99 by scrolling down.
c/ To store a scene press STORE in the scene is new then it will just be stored and the
screen will display done. If the scene already exists then the display will read
over_str and you will need to press the confirm button. The screen will then read done.
a/ Pressing the MIDI button places you in the midi menu.
b/ Using the UP and DOWN buttons scroll through OUT01 to 04 until the required
message is reached. (On the Heritage there are a maximum of 4 midi out messages
that can be sent per recalled scene). Press CONFIRM.
c/ Using the UP and DOWN buttons scroll through the menu until the screen reads PROG.
Press the CONFIRM button
d/ The window will read CH00, using the UP and DOWN keys a channel between
01 to 16 can be selected. Press CONFIRM.
e/ The window P000, using the UP and DOWN keys a program, change between
00 and 127 can be selected. Press confirm and you will be dropped back to the first
level of the menu. When the desired messages have been edited press the MIDI button
again to drop out of the menu.
f/ To then store the midi information with the scene the STORE button must be pressed
followed by CONFIRM.
a/ Once you have created the scene you wish to insert edit the act/scene number display
using the ACT/SCENE, UP and DOWN buttons until the desired position is displayed.
b/ Press the INSERT switch. The screen will then display . The original scene and
any scene preceding it will then be incremented by one position.
NB The INSERT button will only be illuminated if a scene exists where you wish to place the scene, otherwise
STORE may be used as normal.
a/ Recall the scene you wish to copy by selecting the scene number and pressing the
NOW button.
b/ Press the COPY button the act/scene numbers can now be scrolled through using the
ACT/SCENE,UP and DOWN buttons. Once the desired position is reached the scene
is copied to that position when the CONFIRM button is pressed.
NB There is a BUG in the software so that once the COPY button has been pressed the screen is not updated.
You can't see were the scene will be placed unless you mentally count the number of up or down button presses,
apart from this the information copied is correct.
done
34
To Next Page