Previewing a Scene:
Recalling Scenes:
To preview a scene without effecting your mix select the scene number on the display using the ACT/SCENE,
UP and DOWN buttons. Once the desired number is displayed using the CHECK button the automated switch
configuration and fader positions stored for that scene can be viewed without changing the actual settings.
Pressing the CHECK button will drop you back into normal mode.
The screen will also display Heritage configuration and Midi data. On 1 issue software the messages scrolled
will also read ERR before the Midi data. This is not indicating any error with the scene but is concerned with
Heritage external communications, which will be solved shortly. This does not effect any part of the operation
of the console.
There are 3 methods by which scenes can be recalled:
a/ Stepping through existing scenes using the LAST and NEXT buttons. This steps
through the scenes in numerical order.
b/ Select the act/scene number using the ACT/SCENE, UP and DOWN buttons, when the
correct scene number is displayed in the screen press the NOW button and the scene
will be recalled.
c/ A scene can be assigned to a fast scene key (1-10). In this instance the scene is recalled
by just pushing the fast scene key.
st
Assigning A Scene To A Fast Scene Key:
Deleting a Scene From A Fast Key:
Deleting A Scene:
a/ Recall the scene you wish to assign to a FAST SCENE KEY.
b/ Press the COPY button, followed by the FAST SCENE KEY button you wish to assign
that ACT/SCENE to. The screen will then display .
a/ Press and hold down the FAST KEY you want to delete.
b/ When the YES and NO button start to flash you can now select either YES or NO to
delete or cancel deletion of the FAST KEY.
Recall the scene you wish to delete, Or display the scene number on the screen using the
ACT/SCENE, UP and DOWN buttons. When this is done press the DELETE button.
You will be asked to confirm this. Press the CONFIRM button the screen will then say
when the scene is deleted.
done
done
35
To Next Page
Loading...