Why does my Heta Wood stove tick?
If your stove ticks, it's due to normal expansion and contraction caused by temperature changes. Ensure that the temperature in the combustion chamber is as constant as possible.
What to do if Heta Stove combustion is too rapid?
If your Heta Stove experiences too rapid combustion, it could be due to: * Too much chimney draft: Measure the chimney draft and install a damper in the flue pipe if necessary. * A defective door or ash pan/drawer seal: Replace the seal.
Why does smoke seep into the room when lighting my cold Heta Stove?
If smoke seeps into the room when lighting your cold Heta Stove, but it burns well once heated, the cause is likely an inadequate chimney draft. To fix this, improve the chimney.
Why is my Heta Stove whistling?
If your Heta Stove is whistling, it's likely due to too much chimney draft. Installing a damper should resolve this issue.
What causes condensation from the Heta Stove flue pipe?
Condensation from the flue pipe of your Heta Stove can be caused by: * A pipe that's too long or a chimney that's too cold: Improve the flue pipe and insulate the chimney. * Damp wood: Ensure you are using dry firewood.
What to do if the vermiculite in my Heta Wood stove combustion chamber is very worn?
Normal wear and minor cracks are of no significance in the vermiculite. It should be replaced when the steel of the combustion chamber is visible.
What to do if my Heta Wood stove smells and the surface is steaming?
If your stove smells and the surface is steaming, it is likely because the paint on the stove surface is not yet fully hardened. Ensure there is sufficient ventilation to address this.
Why is there condensation in my Heta Wood stove combustion chamber?
Condensation in the combustion chamber can be caused by moisture in the vermiculite (evaporates by itself after the stove has been lit a few times), damp wood (use dry firewood), or a pipe that is too long or a chimney that is too cold (improve the flue pipe, insulate the chimney).
Why is my Heta Stove ticking?
If your Heta Stove is ticking, it's due to normal expansion and contraction caused by temperature changes. Ensure that the temperature in the combustion chamber is as constant as possible.
Why does my new Heta Stove smell and steam?
If your Heta Stove smells and the surface is steaming, it's likely that the paint on the stove surface is not yet fully hardened. Ensure there is sufficient ventilation to allow it to harden properly.
General| Brand | Heta |
|---|---|
| Model | Inspire 40H |
| Category | Indoor Fireplace |
| Language | English |
To Next Page
