Before you begin 4
Before you begin
Overview
This document provides instructions for directly connecting one or two HP ProLiant DL/ML/SL servers with
Smart Array P212, P411, and P812 Controllers into the HP StorageWorks 600 Modular Disk System.
Cabling guidelines for MDS600
Observe the following guidelines:
• No cables ship with the MDS600. The only supported cable length that can be used is the 2.00 m
(6.56 ft.) mini-SAS cable.
• 8x wide SAS cables are not supported.
• The MDS600 has two drawers. Each drawer is an independent unit. A separate connection will be
needed for each drawer.
• The MDS600 does NOT support cascading I/O modules.
• Always be sure that the servers attached to the MDS600 are powered down before connecting SAS
cables.
To Next Page
Loading...