2. Safety rules
A. Power Supply Requirements
Power box
Input: 110 - 240 Volts AC
50-60 Hertz
Output: <30 VDC
General protection index: IP54
Observe your electrical obligations for the installation of the power supply
boxes
of 220V / 110V (NFC15-100).
Robot excluding socket on power supply unit
Voltage: <30VDC
Protection index: IP68
B.
Water Requirements
The pool vacuum cleaner SPOT PRO 100 is designed for cleaning the pools under the
following water conditions:
• T
emperature: 6°- 38° C / 43° - 100° F
• Chlorine: 0.6 - 4 ppm
• pH: 7.0 - 7.8
• Maximum salinity level (NaCl) = 5,000 ppm
• No sulfur water.
Basin depth:
• Minimum: 0.30m / 1 foot
• Maximum: 5m / 16.4 feet
C. Rules for safe use
• Never use the pool vacuum cleaner SPOT PRO 100 when
anybody, especially children or pets, is in the pool or basin.
• Never let the vacuum cleaner SPOT PRO 100 collide with people or
other living things.
• The pool robotic vacuum cleaner SPOT PRO 100 can only be used,
maintained and repaired by persons who are familiar with its special
features and the safety instructions. Please read the user manual
carefully and thoroughly familiarize yourself before using the pool
robotic vacuum cleaner SPOT PRO 100.
• Do not place anything, except the radio remote control, on the
pool vacuum cleaner SPOT PRO 100 or its electric control box.
• Never attempt to repair a damaged power cable. Contact your
dealer for a replacement by the original cable to avoid any injury.
• Do not use the pool vacuum cleaner robot SPOT PRO 100 if you notice a
problem on a part of the robot or see a defective or missing element (pump,
turbine, screws, nuts or cables...).
www.myhexagone.com • info@myhexagone.com • Tél. +33 1 34 34 11 55
5
To Next Page
