The value settings in this feature do NOT affect the charge
or discharge process, but rather allows you to store
statistics for commonly charged batteries to speed up the
charger setup time. To use this feature, you will want to
change the parameters to the exact specifications of the
batteries you wish to store. This example shows a 12 cell,
NiMH battery with a capacity of 3000mAh.
Set up the charge current for manual charge mode, or the
current limit for automatic charge mode. Each mode can be
changed by pressing the increase/decrease buttons at the
same time when the "current" field is blinking.
Setting up discharge current and final voltage.
Setting up the sequence of charge and discharge as well as
the amount of times to cycle.
Saving the data.
.
WWW.HEXFLY.COM
To Next Page
Loading...