HeyCafe HC-880 - Troubleshooting Manual

Troubleshoo�ng: HeyCafe HC-880
Fault Cause
Remedy
The grinder is
not grinding,
the display is
not lit up.
The grinder
is making
n
oise but
not
grinding.
• The mains plug is
not plugged in.
•
The thermal cut-
out has tripped.
•
The electrical fuse
has tripped.
•
The grinding
mechanism is
clogged. / The
grinding degree is

•

built up in the
grinder because of
an excessive

•
A foreign object
has got into the
grinding
mechanism.
 insert the power plug into a properly
installed socket.



the socket and allow the grinder to cool
down for 30 minutes. replace the power plug


grinder again as normal. if the cut-out trips
repeatedly, contact a service technician for
support.

Check the electrical fuse. if required, restore
the fuse to its original state or replace it.
Check whether other loads are connected to
this fuse and if so, pull out their plugs. if the
fuse repeatedly trips, contact a service
technician for support.



grinder will clear itself. Then set the desired



spout including the spring using a brush. Set

and start the grinding process. The grinder
will clear itself. Then set the desired grinding


Clean the grinder See HeyCafe HC-880 User
Manual Chapter 9, “Cleaning the Grinding
Chamber” for 
grinding chamber
the foreign object. If the foreign body cannot
be removed in this way, further

Hey Café