HG2 Runner - User Manual

FOR TECHNICAL ASSISTANCE, VISIT www.hg2lighting.com/help
1
PARTS LIST
1 – XX” HG2 Runner – Rear of Vehicle
1 – RPM12 Runner Platform Module
1 – Pattern Selector Button
1 – 7A Fuse
1 – 1/4” Grommet
1 – Installation Guide and Warranty Info Packet
REQUIRED TOOLS
• Drill
• 9/32” and 5/16” Drill Bits
• Phillips-head Screwdriver/bit
• Wire Strippers
• Wire Crimping Tool
• Electrical tape
• Wire/Cable Ties
• 5/16” or 10mm Wrench (for battery connections)
Additional tools may be required to complete
installation.
INSTALLATION
Preparation
1. Read the installation guide for this product in its
entirety.
2. Unpack product components and review parts list.
3. Bench test control module and runner using 12v
power supply to ensure components are in working
order.
4. Remove rear hatch sill panel.
5. Place vehicle on vehicle lift or jack stands.
Mounting
1. Open rear hatch/doors.
2. Test fit rear HG2 Runner assembly in opening.
Assembly should lay on top of bumper with end
caps butting against front sill of bumper.
3. Take note of location to drill for wire routing.
Perform visual inspection under vehicle, behind
bumper, to ensure drilling and wire routing will not
interfere with existing systems or heat sources.
Rear Mount:
2007 – 2012 Chevrolet Tahoe
2007 – 2012 GMC Yukon
HG2 Runner assembly centered in opening.
End caps butt to front sill of bumper.
Location to drill for wire routing. Inspect to ensure drilling
or wiring will not interfere with vehicle systems.

Summary

Mounting HG2 Runner Assembly

Open Rear Hatch;Doors

Begin the mounting process by opening the rear hatch or doors of the vehicle.

Test Fit Assembly

Place the HG2 Runner assembly in the opening to verify fit and alignment.

Identify Wire Routing Location

Determine and note the position for drilling to route the necessary wiring.

Installation Steps

Preparation and Bench Testing

Read the guide, unpack, bench test components, remove sill panel, and secure vehicle.

Drill Mounting Hole and Insert Grommet

Drill a 5/16" hole and insert the supplied 1/4" grommet for wiring.

Clean and Prepare Mounting Surface

Clean the bumper mounting area with soap/water and an alcohol wipe.

Mount Runner Assembly

Feed wiring through grommet, remove tape backing, and press assembly to secure.

Route Wiring to Module

Carefully route wiring to the Runner Platform Module, avoiding obstructions.

HG2 Runner Specifications

General

Brand	HG2
Model	Runner
Category	Automobile Accessories
Language	English