Need help?Do you have a question about the HGG PCL 600 and is the answer not in the manual?
Details necessary qualifications and duties for operators and mechanics to ensure safe operation.
Provides essential safety instructions and lists required personal protection equipment (PPE).
Identifies potential hazards and describes the meaning and placement of safety labels.
Explains the emergency stop button, its effect, and the procedure to restart the machine safely.
Explains the layout and functions of the touch screen interface for machine control.
Describes modes for profiling (infeed, cutting, outfeed) and calibration, including specific button functions.
Details specific touch screen buttons for managing material flow and cutting cell operations.
Explains procedures for homing machine components and performing manual movements.
Lists essential checks and the step-by-step procedure for starting up the machine.
Details the sequence of actions required to initialize the machine, including powering on and homing.
Describes the process for running the machine in automatic cutting mode from start to finish.
Guides through the automated procedures for calibrating machine clamps and the active frame.
Step-by-step guide on creating a specific cutting file in ProCAM for tool calibration.
Details ProCAM operations for defining the calibration part, macros, and properties.
Describes the process of cutting the programmed calibration piece using the machine.
Explains how to measure the cut piece and input the values into the calibration dialog.
To Next Page
General