hi-Fun hi-Ring - Switch on and Pairing

Switch on
To switch on hi-Ring Bluetooth hold the middle button (3) until warning LED
(1) comes on violet. Afterwards hi-Ring Bluetooth automatically connect
itself to the last paired device, if available, and LED ash in blue to conrm
the connection. If there is no available paired device or if it is out of reach
of hi-Ring Bluetooth, it turns off in about 4 minutes in order to avoid battery
dischargnig.
Pairing
To pair for the rst time, pair for a second time or to pair to a different
device, hi-Ring Bluetooth must be set in pairing mode, signaled by the
warning LED (1) which ashes alternately and quickly in red and blue.
To activate the pairing mode you need to switch off hi-Ring Bluetooth and
switch it on holding the central button (3) until the warning LED (1) will
ash alternately and quickly red and blue.
Now you can select hi-Ring Bluetooth from the list of found devices on
your device. As soon as the device is paired the warning LED (1) ashes
slowly in blue.
Now is possible to make and receive calls with hi-Ring Bluetooth.