Need help?Do you have a question about the Hi-Link HLK-7628N and is the answer not in the manual?
General| Brand | Hi-Link |
|---|---|
| Model | HLK-7628N |
| Category | Control Unit |
| Language | English |
Introduces the HLK-7628N module and its purpose.
Details the technical specifications of the HLK-7628N module.
Provides information about the hardware components and features.
Provides initial steps for setting up and configuring the module.
Instructions for restoring the module to its factory default settings.
Describes various operating modes like Serial to Ethernet, WiFi Client, and WiFi AP.
Details data conversion modes: TCP Server, TCP Client, UDP Server, UDP Client.
Details the web interface for configuring network and serial port settings.
Explains how to configure the module using AT commands via serial interface.
Commands for setting network mode, WiFi SSID, encryption, and channel.
Commands for setting remote IP, port, protocol, and timeout.
Commands for configuring IP, DNS, and DHCP server parameters.
Commands for configuring UART parameters like baud rate, data bits, parity, and stop bits.
Commands for setting serial frame length and timeout.
Commands for TCP auto reconnect, saving settings, and restarting services.
Commands for checking firmware version, client status, and MAC address.
Commands specific to Serial port 2 for network and connection settings.
Provides AT commands to query current configuration information.
Provides AT command sequences for Serial to Ethernet configurations.
Provides AT command sequences for Serial to WiFi configurations.
Provides AT command sequence for performing a factory reset.
Describes the utility for configuring modules through serial ports.
Explains how to save and manage user parameters in the configuration tool.
Describes how to perform a factory reset using the tool's interface.
Introduces the tool for searching HLK-7628N modules on the network.
Explains the methods for performing a factory reset on the module.
Provides instructions for upgrading the module's firmware.
To Next Page
