64
64
PAR Description
+10
-12
-5
-15
PAR
funcionamiento normal
0=switched off; 1=switched on; see also F13, F14 and i10; 2=in parallel with the compr.; see also F9, F13, F14 and i10; 3=dependent on F1 [17];
4=switched off if the compr. is switched off, dependent on F1 if the compr. is switched on; see also F9 [16]; 5=dependent on F6; see also F9
F1
evaporator temp. above the limit at which the evaporator fan is switched off
14 0 -2 -2 F1
F2
evaporator fan activity during defrosting and dripping
0=switched off; 1=switched on (setting parameter d7 to 0 is recommended); 2=dependent on F0
0 0 0 0 F2
F3 maximum duration of evaporator fan disactivatione de
0 4 0 0 F3
F4
time duration that evaporator fan is switched off during operation for a low RH% when the compressor is switched off
40 40 40 40 F4
F5 time duration that evaporator fan is switched on during operation for a low RH% when the compressor is switched off 20 20 20 20 F5
F6
operation for low or high percentage of relative humidity / alta o bassa umidità relative
evap. fan operate with compr.; see also F4 & F5; 1= high RH%
0 0 0 0 F6
F7
evaporator temp. below limit at which the evaporator fan is disactivated (“setpoint + F7”);
5 5 5 5 F7
F8
parameter F1 differential
F9 0 0 0 0 F9
F12 0 0 0 0 F12
F13 40 40 40 40 F13
F14 20 20 20 20 F14
i0
effect caused by the activation of the door microswitch input
0=any; 5=the evap. fan will be switched off (at most until time i3 or until the input has been disactivated) and the cell light will
be switched on (if u1 and/or u11 = 0, until the input is disactivated) [20]
5 5 0 0 i0
i1
type of door microswitch input contact
0=normally open (active input with closed contact); 1=normally closed (active input with open contact
0 0 0 0 i1
i2
delay in signaling of door microswitch input alarm
5 5 5 5 i2
i3
maximum duration of the effect caused by activation of the door microswitch on the compressor and the evaporator fan
15 -1 15 15 i3
i4
storage of door microswitch input alarm [21]
1 1 1 1 i4
i10 0 0 0 0 i10
i11
minimum time the door switch input must be activated such as to provoke the exclusion of the consequent value of the evaporator temp.
among the ones used for the calculation of the relative average (for the defrost activation; if d8 = 3);
15 15 15 15 i11
i12 60 60 60 60 i12
0 0 0 0 i13
i14
minimum duration of the door switch imput activation such as to provoke the defrost activation
0 6 6 6 i14
u1
Operation controlle
d by 4
th
output 0= cell light; 4= door resistors
0 4 4 0 u1
u2
Enabling of manual switch on/off of the cell light or the auxiliary output when the instrument is switched off (only i
f
u1=0 or 2)
[24]
0 0 0 0 u2
u4
Enabling of alrm output diactivation with the silencing of the buzzer (only if u1=3)
1 1 1 1 u4
delay in the switching off of evaporator fan following the switching off of the compressor (if F0 = 2, 4 and 5)
delay in switching off of the condenser fan following the switching off of the condenser (if u1 and/or u11 = 6)
time evaporator fan remains OFF during function Energy Saving; see also F14 and i10 (if F0=1 or 2)
time evaporator fan remains ON during function Energy Saving; see also F13 and i10 (if F0=1 or 2)
time without activations of the door switch input (on condition that the cabinet temp. has reached the working setpoint) in order that
function Energy Saving is activated automatically
minimum time the door switch input must be activated altogether such as to provoke the exclusion of the consequent value of the
evaporator temp. among the ones used for the calculation of the relative average (for the defrost activation; if d8 = 3 /
i13
number of door switch input activations such as to provoke the defrost activation / derartige
To Next Page
Loading...