01 02 03 04 05 06 07 08 09 10 12 13 14 15 16 17 18 19 20 21
22 23 24 25 26 27 28 29 30 31
EN
Extracting coffee
I. Insert the ground coffee container into the Nespressocapsule seat. Insert it into the main unit, making sure to tighten
it securely.
2. Put the product into the cup, then rotate the top cover to remove it, pour the appropriate amount of cold water, and then
rotate the top cover.
3. Connect the product to the DC12V power supply, then press the switch to start the product and wait for 5-7 minutes fora
cup of coffee.
1
Cleaning
After making coffee every time
2 3
1. After the standby unit is completely cooled, remove and discard the used coffee capsules in the base.
2. Rinse the base with clean water. There are many mesh holes at the bottom of the base. Pleaseuse a brush to rinse and ensure that
the mesh is not blocked.
3. The main body can be scrubbed with a damp cloth.
Note : The main body cannot be soaked in water.
Questions / answers
1. The indicator light flashes quickly and cannot work
O
This is because the heater temperature is too high, the product is protected. If there is no water, please add Before filling
the tank, disconnect the unit from the power supply. Oncethe tank is full, plug the unit back in and turn it back on.
2. Water leaks at the capsule seat connection :
This is because the capsule seat is not tightened, please tighten the capsule seat.
3. The indicator is not lit and cannot work :
This is because the power supply is not connected and please reconnected.
4. When the machine is in the heating state, the ON/OFF button flashes the r ed light, and when the machine is not heated, the blue
light flashes.
5. When the machine is powered on, the ON/OFF button flashes red twice and blue twice. After the blue light blinks twice, pr ess
the On/key again to start making coffee. Ifthe machine does not work after first pr essing the button, please press it again.
03
To Previous Page
Loading...