BEFORE THE FIRST USE
PRE-HEATING
To ensure the first cup of coffee tastes excellent, you should rinse the coffee
maker with warm water as follows:
Pour water into water tank, the water level should not exceed the “MAX” mark
in the tank. Then replace the water tank cover.
Note: the appliance is supplied with a detachable tank for easy cleaning,
you can fill the tank with water firstly, and then put the tank into the
appliance.
Set steel mesh into metal funnel (no coffee in steel mesh).
Place an jug on removable shelf. Make sure the steam control knob is on the
OFF position.
Note: the appliance is not equipped with jug, please use yourself jug or
coffee cup.
Connect to power source, Press the power button “ ” one time, the red
indicator is illuminated.
Press the pump control switch , the pump will pump water, when there is
water flowing out and close the pump by pressing the pump control , press
the coffee/steam selector and wait for a moment, the appliance begins to be
pre-heated until the inner lamp of pump control switch is illuminated, it
shows the pre-heating is finished. Press the pump control switchand water
will flow out.
After water does not drop out any more, you can pour the water in each con-
tainer out then clean them thoroughly, now you can start brewing.
Note: There may be noise when pumping the water for the first time, it is
normal, the appliance is releasing the air inside. After about 20s, the
noise will disappear.
1.
2.
3.
4.
5.
6.
To make a cup of good hot Espresso coffee, we recommend you preheating
the appliance before making coffee, including the funnel, filter and cup, so
that the coffee flavour can not be influenced by the cold parts.
1.
2.
3.
4.
Remove the detachable tank and open the tank cover to fill it with desired
water, the water level should not exceed the “MAX” mark in the tank. Then
place the tank into the appliance properly.
Select the two –cup mesh, Set steel mesh into metal funnel, make sure the
tube on the funnel aligns with groove in the appliance, then insert the funnel
into the appliance from the “Insert” position, and you can fix them into coffee
maker firmly through turn it anticlockwise until it is at the “Lock” position.
Place an espresso cup on removable shelf.
Then connect the appliance to power supply. Make sure the steam control
knob is on the OFF position.
01 02 03 04 05 06 07 08 09
To Next Page
Loading...