Maintanance
9. Remove the gasoline from the integral fuel tank.
10. If “Fogging Oi1” is not available, remove the spark plug. Pour a teaspoonful of clean engine
oil into the cylinder. Crank several times manually. Replace the spark plug.
11. Install the top cowling.
12. Drain the cooling water completely out of the motor. Clean the body thoroughly.
Lubrication
1. Grease the spark plug threads and install the spark plug(s) and torque to proper specication.
2. Change the gear oil.Inspect the oil for the presence of water that indicates a leaky seal.
3. Grease all grease ttings.
Cleaning the outboard motor
After use, wash the exterior of the outboard motor with fresh water. Flush the cooling system with
fresh water.
Checking painted surface of motor
Check the motor for scratches, nicks, or aking paint. Areas with damaged paint are more likely
to corrode, if necessary, clean and paint the areas.
Periodic maintenance
WARNING
Be sure to turn off the engine when you perform maintenance unless otherwise specied. If you
or the owner is not familiar with machine servicing, this work should be done by your HIDEA
dealer or other qualied mechanic.
Replacement parts
If replacement parts are necessary, use only genuine HIDEA parts or parts of the same type and of
equivalent strength and materials. Any part of inferior quality may malfunction, and the resulting
loss of control could endanger the operator and passengers. HIDEA genuine parts and accessories
are available from your HIDEA dealer.
30
To Next Page
Loading...
