Hidoes HD-B10 - User Manual

Questions and Answers

K
Kenneth JordanAug 18, 2025
Why are the brakes on my Hidoes HD-B10 Scooter not effective?
- C
  Cesar BaldwinAug 19, 2025
  If the brakes on your Hidoes Scooter aren't working well, it could be due to several reasons. The pads might be worn and need replacement. Alternatively, the pads or discs could be dirty, requiring cleaning and degreasing. Inspect the brake cables for binding, stretching, or damage; lubricate, adjust, or replace them as needed. Also, check if the brake levers are binding and clean the pivots, or simply adjust the brakes.
S
Stephen ThomasAug 20, 2025
How to fix grinding noise when pedaling Hidoes HD-B10 Scooter?
- K
  Kenneth LewisAug 21, 2025
  Grinding noises while pedaling your Hidoes Scooter can arise from several issues. The pedal or bottom bracket bearings might be too tight and require adjustment. Ensure the rear wheel is aligned so the chain runs straight. The chain itself may be too tight, needing adjustment. A dirty derailleur can also cause this, so clean and lubricate it.
N
nicholasnewmanAug 23, 2025
What to do if Hidoes Scooter brakes squeal?
- M
  meganpearsonAug 23, 2025
  If your Hidoes Scooter brakes are squealing, the pads or discs might be dirty and need cleaning and degreasing. Another cause could be that the brakes are not centered, so centering them and making adjustments is recommended. Also, check the calliper fasteners and tighten if loose.
J
jeffrey21Aug 26, 2025
Why does my Hidoes Scooter wheel vibrate or wobble?
- D
  Dana ReyesAug 26, 2025
  Wheel vibration or wobble in your Hidoes Scooter can stem from a few potential issues. The axle might be bent or broken, necessitating replacement. The wheel could be out of true and require truing. Check if the wheel hub bearings are loose or not serviceable; adjust or replace them as needed. Also, if your scooter has a quick-release mechanism, ensure it is properly adjusted.
E
Erika CoffeyAug 28, 2025
Why do the brakes on my Hidoes HD-B10 Scooter chatter or vibrate?
- M
  Meredith JonesAug 28, 2025
  If your Hidoes Scooter brakes chatter or vibrate, start by checking the brake mounting bolts and tightening them if they are loose. Also, the brakes might be out of adjustment, so centering them and making the necessary adjustments is advisable. Loose steering head bearings can also cause this issue, so adjust the bearings accordingly.
H
Heather WilliamsAug 30, 2025
Why is the pedal assistance on my Hidoes HD-B10 Scooter not working correctly?
- N
  Nicholas WilsonAug 30, 2025
  If the pedal assistance on your Hidoes Scooter is operating intermittently or not as expected, begin by inspecting the connectors and wiring for looseness or damage and replace as required. A faulty controller, crank sensor, or throttle could also be the cause, requiring replacement.
M
Mark RasmussenSep 1, 2025
What causes a Hidoes HD-B10 Scooter to run at full speed without pedaling?
- J
  Jessica MitchellSep 1, 2025
  If your Hidoes Scooter runs at full speed without pedaling, it could be due to a faulty crank sensor, throttle, or controller, each of which would need to be replaced.
M
Matthew CunninghamSep 3, 2025
Why does my Hidoes Scooter motor click or lose power?
- B
  Brian RoachSep 4, 2025
  If your Hidoes Scooter motor clicks, has reduced power, or shuts off, it could be due to an under-charged battery, so charge the battery, following battery care procedures. Alternatively, there may be an internal fault with the motor, in which case replacement is necessary.
J
James CookSep 6, 2025
Why is there no display on my Hidoes HD-B10 Scooter but pedal assistance is OK?
- C
  Christian DavisSep 6, 2025
  If your Hidoes Scooter has pedal assistance OK, but no display, check the connectors and wiring for looseness or damage and replace as required. A faulty controller could also be the cause, requiring replacement.
D
Denise FitzgeraldSep 8, 2025
Why does my Hidoes Scooter have a display but no pedal assistance?
- E
  Edward SharpSep 8, 2025
  If your Hidoes Scooter has a display but no pedal assistance, check the motor connectors and wiring for looseness or damage and replace as required. Inspect and clean the battery terminals to ensure good contact. A faulty braking sensor could also be the issue, requiring replacement.