Need help?Do you have a question about the HidrateSpark 3 and is the answer not in the manual?
Turn the bottle upside down and unscrew the battery cover from the base.
After removing the battery cover, insert the battery into the sensor.
The sensor will illuminate with a startup sequence after battery insertion.
Secure the battery cover back on the bottle base, avoiding overtightening to prevent damage.
Ensure lid seal and inner lid arrows align to prevent leakage.
Slide the finger loop under the lid's metal pin and loop it through itself.
Download the free Hidrate Spark Smart Water Bottle app from the App Store or Google Play.
Connect to the internet and Bluetooth, then set up your account and personalized hydration goals in the app.
Sync the app near the bottle daily after refills for accurate water tracking.
Wash the bottle thoroughly before the first use.
Rinse the bottle immediately after each use with the lid in the open position.
The Lid and Bottom Ring are safe for top-rack dishwashing.
The Sensor Stick and bottle body must be hand washed only.
Store bottle with parts removed to ensure complete drying.
CR2477 Lithium batteries are a choking hazard during replacement.
The product is designed for cold liquids only; do not use with hot liquids.
Adding ice may lead to inaccurate hydration measurements.
Not suitable for carbonated or pulpy beverages.
Ensure the lid is properly threaded and fully screwed on before drinking.
Do not overfill; keep liquids at or below the fill line to prevent spills.
Do not microwave or freeze the bottle.
Avoid cleaners with bleach, chlorine, abrasives, or harsh chemicals.
Discontinue use if the product is damaged.
Avoid carrying bottles with liquid inside bags to prevent accidental opening.
Contact support via website chat, email, or through the app's Settings > Help section.
Visit hidratespark.com/pages/guide for more information and best practices.
General| Brand | HidrateSpark |
|---|---|
| Model | 3 |
| Category | Personal Care Products |
| Language | English |
To Next Page
