What to do if Hidro-Water Medical Equipment has unpleasant taste and smell?
If your Hidro-Water Medical Equipment produces water with an unpleasant taste and smell, it is likely due to contamination. You should replace the filters, membrane, and postfilter, and also sanitize the system.
What to do if Hidro-Water NEREO has zero or low production?
If your Hidro-Water Medical Equipment has zero or low production, several factors could be responsible: * Check if the water supply has been restored. * Ensure the brass ball valve at the entrance is fully open. * Confirm the storage tank ball valve is fully open. * Verify the mains pressure is above 2.5 bars; if not, install a pump. * Inspect the storage tank for punctures or damage; replace if necessary. * Check and pressurize the storage tank to at least 0.25 bars when empty. * Replace obstructed flow restrictors or cartridges. * Unblock any obstructions in the drain line. * Replace the membrane if saturated. * Check the power supply and transformer output; replace the transformer if there's no voltage. * If the pump isn't increasing pressure, replace it.
Why Hidro-Water Medical Equipment osmosis system doesn’t stop throwing water away?
If the Hidro-Water Medical Equipment osmosis system continuously throws water away, it could be due to: * A deteriorated shut-off valve (replace it). * A deteriorated non-return valve (replace it). * Excessive inlet pressure (fit a pressure regulator if the mains pressure exceeds 4 bars). * Very little air in the storage tank (pressurize the tank to between 0.25 and 0.4 bars when empty).
What causes excessive production and elevated TDS in Hidro-Water NEREO?
Excessive production or elevated TDS in your Hidro-Water Medical Equipment can be caused by several issues: * The membrane might not be fitted; ensure it is properly installed. * Damaged membrane O-rings should be replaced. * A damaged membrane housing requires replacement. * A damaged membrane should be replaced. * Badly connected tubes: Wire the connection between the wastage and the permeate properly. * If the shut off valve is damaged, replace it.
Why Hidro-Water NEREO Medical Equipment osmosis system starts up sporadically without water consumption?
The Hidro-Water Medical Equipment osmosis system starting sporadically without water consumption can be attributed to: * A deteriorated non-return valve, which should be replaced. * Excessive inlet pressure; if the mains water pressure exceeds 4 bars, install a pressure regulator. * A leak in the system or faucet; repair the leak or replace the faucet.
Why Hidro-Water NEREO Medical Equipment osmosis system stops and starts?
If the Hidro-Water Medical Equipment osmosis system frequently stops and starts, the possible causes are: * Very low inlet pressure (lower than 1 bar): Bypass the minimum pressure switch. * A faulty minimum pressure switch: Replace it. * A deteriorated non-return valve: Replace the non-return valve.
How to fix high pressure in the storage tank of Hidro-Water Medical Equipment?
To fix high pressure in the storage tank of your Hidro-Water Medical Equipment, check the pressure when the tank is empty. It should be between 0.25 and 0.4 bars. If necessary, depressurize the tank.
What causes a bitter or acidic taste in Hidro-Water Medical Equipment?
A bitter or acidic taste in water from your Hidro-Water Medical Equipment is likely due to water with a very low salinity level. Fitting a mineralizing postfilter should resolve this issue.
What causes a plastic or synthetic taste in Hidro-Water Medical Equipment?
A plastic or synthetic taste in the water from your Hidro-Water Medical Equipment is likely due to a worn postfilter. Replacing the postfilter should resolve this.
General| Brand | Hidro-Water |
|---|---|
| Model | NEREO |
| Category | Medical Equipment |
| Language | English |
To Next Page