HIDROCONTROL Water Drive Series

Questions and Answers

O
omyersAug 4, 2025
What to do if overcurrent is detected in the pump of HIDROCONTROL Water Drive?
- L
  lukecookeAug 4, 2025
  If you're experiencing overcurrent issues with the pump on your HIDROCONTROL DC Drives, start by checking the current measurement output at parameter 36, labeled 'LoadCurrent,' and ensure it's set to the correct maximum current value. Also, verify that the pump is operating within the conditions specified by its manufacturer. Finally, check for any friction or locking issues with the impeller.
C
ccherryAug 9, 2025
How to fix short circuit detected between phases or phase and ground in HIDROCONTROL Water Drive?
- J
  Jessica MontoyaAug 10, 2025
  If a short circuit is detected between phases or phase and ground in your HIDROCONTROL DC Drives, first remove the short circuit. Then, check the motor's current absorption to ensure it's correct. Disconnect the power supply, wait for the display to switch off, and then restore the power supply.
B
Blake JonesAug 16, 2025
What to do if the supply voltage is too low for HIDROCONTROL Water Drive DC Drives?
- M
  Michael JohnsonAug 16, 2025
  If the supply voltage is lower than permitted for your HIDROCONTROL DC Drives, which means it's below 170 VAC, inspect the electrical system. Reset the voltage values to fall within the range specified for the WATER DRIVE.
K
Keith RamirezAug 22, 2025
What to do if the supply voltage is too high for HIDROCONTROL DC Drives?
- J
  jacksonbriannaAug 22, 2025
  If the supply voltage is higher than permitted for your HIDROCONTROL DC Drives, specifically exceeding 270 VAC, examine the electrical system. Adjust the voltage values to stay within the range specified for the WATER DRIVE.
J
John SandersAug 27, 2025
How to unlock a blocked WATER DRIVE in HIDROCONTROL DC Drives?
- N
  Nicole Bradford MDAug 28, 2025
  If the WATER DRIVE is blocked in your HIDROCONTROL DC Drives, set the number of short circuit attempts to zero. If the problem continues, try to reset the drive manually by unplugging the pump.