SNOWPAD REVERSE OSMOSIS GUIDE
Ver 2-2023
INSTALLATION PROCEDURE
Installing drain clamp:
1..Place drain clamp on drain pipe above the drain trap and
tighten securely.
2..Using the drain clamp as a guide, drill a 6mm hole, enough for
the 1/4” tubing to pass through one side of the drain pipe.
DO NOT drill through both sides.
3..Connect Red Waste Water tubing from unit to Drain Clamp.
CAUTION: When cutting the tubing, make it clean, square. cuts ,failing to
do so result in poor connection and possible leaks.
The lowest point of the line should be the point of connection to the Drain
Clamp.
There should be no sag in the line as this may cause excessive noise as the
reject water is owing to drain.
Installing video of drain clamp saddle:
https://youtu.be/zOsRXLczMWU
HOME
INSTALLATION
REQUIREMENTS
INSTALLATION
GUIDE
REPLACEMENT OF
FILTERS
PROCEDURE
FILTERS
DISCONNECTION
PROCEDURE
To Next Page
Loading...