Need help?Do you have a question about the Hifonics HFEQ and is the answer not in the manual?
General| Type | Equalizer |
|---|---|
| Channels | 4 |
| Frequency Response | 10 Hz - 50 kHz |
| Dimensions | 7.5" x 4.5" x 1.5" |
| S/N Ratio | > 90 dB |
| THD | < 0.05% |
| Boost/Cut | +/- 12 dB |
| Slope | 12 dB/octave |
| Signal to Noise Ratio | > 90 dB |
| Output Voltage | 4 V |
| Input Impedance | 10k Ohms |
| Center Frequencies | 1 kHz, 4 kHz, 16 kHz |
| Frequency Range | 10Hz - 40kHz |
Describes the L&R unbalanced inputs routed to the internal EQ and outputs, selectable by switch.
Allows adjustment of input level to match source unit line-level sensitivity.
Controls the audio level, adjusted by the illuminated volume knob.
Manages the Subwoofer Output level via the illuminated volume knob.
Adjusts the Front and Rear output levels.
Selects Input channel 1 or 2 for independent control.
Allows changing control knob back light illumination color from Red to Blue.
Adjusts Sub Bass volume at 45Hz.
Adjusts Mid Bass volume at 120Hz.
Adjusts Mid Bass volume at 2.2KHz.
Adjusts Treble volume at 12KHz.
High Pass outputs for connecting to amplifier inputs.
Low Pass outputs for subwoofer amplifier inputs.
Selects stereo or mono for the subwoofer output.
Chooses frequency settings or full range for subwoofer output.
Input jack for power, ground, and remote connections.
Connects to a constant or switched +12 volt source with a 10 amp fuse.
Connects to a clean chassis ground point, ensuring paint removal for contact.
Connects to the source unit remote or antenna wire for +12V signal.
To Next Page