Need help?Do you have a question about the Hifonics HFXR and is the answer not in the manual?
General| Type | Electronic Crossover |
|---|---|
| Frequency Response | 10 Hz - 30 kHz |
| Crossover Slope | 12 dB/Octave |
| Input Impedance | 10k Ohms |
| Output Impedance | 100 Ohms |
| S/N Ratio | 95dB |
| Output Level | 9V |
Provides a single Octave boost at 12dB at 45Hz for smooth and accurate bass response.
Ensures constant voltage regardless of battery voltage for consistent output performance.
Allows multiplication of crossover frequency points for precise system settings.
Enables rear signal output from a single input source without adaptors.
Features front/rear pre-amp inputs with independent front, rear, and subwoofer outputs.
Allows adjustment of output signal levels for various channels.
Selects stereo or mono mode for the subwoofer output.
Features an under-dash module for adjusting the Low-Pass level remotely.
Describes power connection, remote turn-on, ground terminal, and power indicator light.
Details front/rear channel signal inputs and mixed in/out terminals.
Explains front and rear channel high-pass frequency selection and multiplier functions.
Covers subwoofer frequency selector, bass boost, phase inverter, and stereo/mono switch.
Describes level controls and output terminals for front, rear, and subwoofer channels.
Details the function of the under-dash mounted remote level control module.
Illustrates wiring for a 2-channel source unit to amplifiers.
Shows wiring for a 4-channel source unit to amplifiers.
Depicts wiring for a 5-channel source unit to amplifiers.
To Next Page