High-End Technology Super Sniper 90 - User Manual

Page 1/34
Super Sniper 90
High Performance EDF Jet for 90mm EDF units
Thank you and congratulations on your decision of buying one of our
EDF Jet Kits.
Before you start building the Sniper 90, please go through the
instructions on the following pages and study the pictures and
building guidelines carefully.
Due to the high speed that this jet is capable of, extra care needs to
be taken during the building process to ensure that the model can
perform flawlessly when in the air later.
You will find that this model is quick and easy to assemble.

Summary

Technical Data for Super Sniper 90

Super Sniper 90 Kit Contents

Step 1: Wing Assembly

Step 2: Main Retract Installation

Step 3: Fan and Elevator Installation

Step 4: Working Rudder Installation

Step 5: Rudder Fin Mounting

Step 6: Rudder Servo Setup

Step 7: Cockpit and Canopy Installation

Step 8: Front Retract System Setup

Step 9: Elevator and Bungee Hook Attachment

Step 10: Fan and ESC Installation Guide

Step 11: Retract Servo and Receiver Mounting

Step 12: Decal Application Process

Step 13: CG and Control Throws Configuration

Center of Gravity (CG) Adjustment

Adjust the model's center of gravity for optimal flight characteristics.

Control Surface Throws and Exponential Settings

Set elevator, aileron, and rudder throws with exponential for responsiveness.

Step 14: Final Pre-Flight Checks

Step 15: First Flight Preparation

Launch Procedure and Initial Trimming

Perform launch, climb, and trim the model for stable flight.

Critical Safety Warnings and Disclaimer

Review safety guidelines, instructor assistance, and operational responsibility.

High-End Technology Super Sniper 90 Specifications