HIGH ONE 973156 - Page 14

24 25
EN EN
Useful information Useful information
C C
Emptying the water container
1
2
1
Pull the drawer lid and carefully
pull out the container.
2
Drain the water from the
container.
3
If lint builds up on the drain cap
of the container, clean it with water.
4
Re-insert the water container.
IMPORTANT:
Never remove the water container while the program is running.
The condensed water in the water container is not suitable for
human consumption.
Remember to empty the water container after each use.
Cleaning the heat exchanger
IMPORTANT:
Clean the heat exchanger when the "Cleaning the heat
exchanger" warning message appears.
Even if the "heat exchanger cleaning warning light" is not
on: clean the heat exchanger after every 30 drying cycles or
once a month.
1
2
3
4
5
6
7
At the end of the drying process, open the door
and wait for it to cool down.
1
Open the maintenance ap as shown.
2
Unlock the heat exchanger cover by turning
the tabs in the direction shown by the arrows.
3
Remove the heat exchanger cover as shown.
4
Clean the front surface of the exchanger as
shown.
5
Position the heat exchanger cover as shown.
6
Lock the heat exchanger cover by turning
the tabs in the direction shown by the arrows.