This quick guide will equip you with the essential information to operate and sell a HighGear Axis, Summit or AltiTech 2. It
includes quick tips and a question and answer section.
Axis/Summit/AltiTech2 Key Features include:
Time, Compass, Barometer, Altimeter, Chronograph, and Alarm
Setting Time & Date
• Press
set/light
button until “ADJUST HOLD” flashes, “HOUR” will display and digits begin to flash.
• Use
start/lap
button (+) and
stop
button (-) to adjust to desired setting.
•
Mode
button will scroll to minute, second, year, month, day, & 24 hour or 12 hour setting.
• Press
set/light
button to lock in information.
• To toggle between Time 1 (T1) and Time 2 (T2), press
stop
button. Hold
stop
button for 2 seconds to set either time for display.
Calibrating the Compass
• THIS COMPASS HAS TO BE CALIBRATED THE FIRST TIME YOU USE IT.
• Press
set/light
button until “CAL HOLD” flashes. When “CAL” appears, rotate the unit clockwise while holding it level for 3 full
rotations, each rotation lasting 10-15 seconds.
• Press
set/light
button and the declination setting screen will appear.
• Use
start/lap
button (+) and
stop
button (-) to adjust digits.
• Use
mode
button to scroll between digits and cardinal direction.
• Press
set/light
button to end calibration.
Setting Barometric Pressure
• Press
set/light
button, “ADJUST HOLD” will flash, “SET CURRENT WEATHER” will scroll at top of display and icons begin flashing.
• Use
start/lap
and
stop
buttons to choose desired icon, then press
mode
button to advance to sea level barometric pressure.
• Once digits start flashing for sea level pressure, use
start/lap
button (+) and
stop
button (-) to adjust digits. When the desired
number is displayed, press
set light
button to lock in information.
/
Setting Altitude
• Press s
et/light
button until “CAL HOLD” appears and digits begin to flash.
• Use
start/lap
button (+) and
stop
button (-) to adjust digits.
• Press
mode
button to access MAX and ACCUMULATED altitudes. Press
stop
button to zero out the max and accumulated altitude.
• Once main altitude displays, the scrolling max and accumulated altitude is set press
set/light
button to exit.
• To add a reading to your log book, press
start/lap
button and hold until “STORED DATA” stops flashing.
• Set altitude either in feet (FT) or meters (M): press
stop
button and hold until the desired setting stops flashing.
Quick Reference Guide for
Axis / Summit / AltiTech 2
Start/Lap
Set/Light
Stop
Mode
Start/Lap
Mode
Set/Light
Start/Lap Set/Light
Stop
Mode
Set/Light
Start/Lap
190 Continuum Dr. Fletcher, NC 28732 828-681-0335 Toll: 888-295-4949 Fax: 828-681-5320 www.highgear.com
To Next Page
Need help?
General
