Highland MY-CS6004W User Manual (English)

Questions and Answers:

B
Brandi HarringtonAug 2, 2025
Why is steam leaking from the lid of my Highland Electric Pressure Cooker?
- N
  Nicole RobertsAug 2, 2025
  If steam is leaking from the lid of your Highland Electric Pressure Cooker, there might be several reasons: * The sealing ring may be improperly installed. Ensure it is correctly placed. * There could be food debris attached to the sealing ring. Clean the sealing ring thoroughly. * The sealing ring might be damaged. Consider replacing it. * The lid may not be closed correctly. Make sure the lid is properly closed.
R
Renee LopezAug 6, 2025
Why does steam come out from exhaust valve non-stop from Highland Electric Pressure Cooker?
- K
  Kenneth ArmstrongAug 6, 2025
  If steam is constantly coming out of the exhaust valve of your Highland Electric Pressure Cooker, it could be due to the exhaust valve not being in the sealing position. Turn the exhaust valve to the sealing position. If the issue persists, the pressure control might have failed.
C
chavezkaitlynAug 11, 2025
What to do if rice is half cooked or too hard in Highland Electric Pressure Cooker?
- S
  Shawn JenningsAug 11, 2025
  If the rice is only half cooked or too hard in your Highland Electric Pressure Cooker, it might be because there was too little water used. Add more water accordingly. Additionally, opening the lid prematurely can cause this issue; after the cooking cycle completes, leave the lid on for 5 more minutes.
J
John WhitneyAug 15, 2025
Why are all indicators flashing on my Highland Electric Pressure Cooker?
- C
  Crystal JamesAug 15, 2025
  If all the indicators are flashing on your Highland Electric Pressure Cooker, it could be due to a bottom sensor fault, high temperature because there isn't water in the inner pot, or a pressure switch fault. Add water according to the requirement and put the inner pot correctly.
B
brentrossAug 19, 2025
Why is rice too soft in my Highland Electric Pressure Cooker?
- K
  Kathryn MartinezAug 19, 2025
  If the rice is too soft when using your Highland Electric Pressure Cooker, it's likely due to using too much water. Reduce the amount of water accordingly in future cooking.
S
Scott ParkerAug 23, 2025
What to do if power indicator doesn't light on my Highland Electric Pressure Cooker?
- J
  Jennifer MedinaAug 23, 2025
  If the power indicator doesn't light up on your Highland Electric Pressure Cooker, the power socket might have a bad contact. Please check the power socket.
A
Alicia BrewerAug 28, 2025
Why is float valve unable to rise in Highland Electric Pressure Cooker?
- T
  Theresa AdamsAug 28, 2025
  If the float valve is unable to rise in your Highland Electric Pressure Cooker, it might be because there is too little food and water in the inner pot. Add water and food according to the recipe.