Highly Components HC-60

To Next Page

HC-60

INSTALLATION MANUAL

Welcome to use HC-60 Infrared Sensor Lamp

The product is an energy-saving automatic sensor lamp, adopting

integrated circuit and precise detecting components. It gathers

automatism, convenience, safety, saving-energy and practical functions.

Its performance is stable. It can identify day and night. The lamp can turn

on when one enters detection field and can turn off automatically when

one leaves detection field.

SPECIFICATION:

Power Source: 220-240V/AC Detection Range: 180°

Power Frequency: 50/60Hz Detection Distance: 12m max(<24℃)

Ambient Light: <3-2000LUX (adjustable) Working Temperature: -20~+40℃

Time Delay: Min.10sec±3sec Working Humidity: <93%RH

Max.15min±2min Installation Height: 1.8-2.5m

Rated Load: 25W (10CS SMD LED, 1500 LM) Detection Moving Speed: 0.6-1.5m/s

FUNCTION:

➢ Can identify day and night: The consumer can adjust working state in different ambient

light. It can work in the daytime and at night when it is adjusted on the “sun” position (max).

It can work in the ambient light less than 3LUX when it is adjusted on the “3” position (min).

As for the adjustment pattern, please refer to the testing pattern.

➢ Time-Delay is added continually: When it receives the second induction signals within the

first induction, it will restart to time from the moment.

➢ Adjustable Time Delay: the length of time delay could be set according to the customers’

requirement, the minimum time of this item is 10sec ± 3sec, the maximum is 7min±2min.

Good Sensitivity Poor Sensitivity

Need help?

Do you have a question about the Highly Components HC-60 and is the answer not in the manual?

Summary

Product Specifications

Product Functions

Day and Night Identification

Allows adjustment of working state based on ambient light levels, from daytime to darkness.

Continuous Time Delay

Restarts timing from the moment the second induction signal is received within the first.

Adjustable Time Delay

Allows users to set the delay time from 10 seconds up to 7 minutes.

Installation and Testing

Installation Steps

Detailed instructions for mounting the sensor lamp, connecting wires, and powering it on.

Testing Procedure

Guide for verifying the sensor's operation, including LUX and TIME knob adjustments.

Troubleshooting

Load Not Working

Checks for correct power connection, load condition, and ambient light settings.

Poor Sensitivity

Addresses issues related to hindrances, temperature, detection field, and installation height.

Automatic Shut-off Failure

Troubleshooting continuous signals, maximum time delay, and power compatibility.