HighPoint RocketRAID 174x - Step 4 Install Freebsd

Rocket RAID 174x FreeBSD Installation Guide
- 2 -
Step 4 Install FreeBSD
1) Start installing the FreeBSD by booting from installation CD.
2) If you are installing FreeBSD 5.0 or earlier versions, skip this step. When “Welcome
to FreeBSD” screen appears, select “6”.
3) When “Hit [enter] to boot immediately or any other key for command prompt”
screen appears, press SPACE key to stop loader from autobooting.
BTX loader 1.00 BTX version is 1.01
Console: internal video/keyboard
BIOS driver A: is disk0
BIOS driver B: is disk1
BIOS driver C: is disk2
BIOS 636kB/74512kB available memory
FreeBSD/i386 bootstrap loader, Revision 0.8
(mailto:jkh@narf.osd.bsdi.com, Sat Apr 21 08:46:19 GMT 2001)
-
Hit [Enter] to boot immediately, or any other key for command prompt.
Booting [kernel] in 9 seconds…
<-press SPACE key
A prompted label "ok" will appear at the bottom of the screen.
4) Insert RR174x driver diskette into floppy drive now. Type in "load diskx:rr174x-x.x"
(without quotation mark) and then press enter.
for FreeBSD 4.3-RELEASE
ok load kernel
ok load disk1:rr174x-4.3.ko
for FreeBSD 4.4-RELEASE
ok load kernel
ok load disk1:rr174x-4.4.ko
for FreeBSD 4.5-RELEASE
ok load disk1:rr174x-4.5.ko
for FreeBSD 4.6.2-RELEASE
ok load disk1:rr174x-4.6.2.ko
for FreeBSD 4.7-RELEASE
ok load disk1:rr174x-4.7.ko
for FreeBSD 4.8-RELEASE
ok load disk1:rr174x-4.8.ko
for FreeBSD 4.9-RELEASE
ok load disk1:rr174x-4.9.ko
for FreeBSD 4.10-RELEASE
ok load disk1:rr174x-4.10.ko
for FreeBSD 4.11-RELEASE
ok load disk1:rr174x-4.11.ko
for FreeBSD 5.0-RELEASE
ok load disk0:rr174x-5.0.ko
for FreeBSD 5.1-RELEASE
ok load disk0:rr174x-5.1.ko
for FreeBSD 5.2.1-RELEASE