8
within 2 m of the charger during charging.
● For long-term storage of the battery, make sure it is
fully charged every half year to ensure the battery
quality. Otherwise, damage may occur.
● DO NOT place the battery near heating or fire source.
Avoid direct sunlight.
● DO NOT swallow the battery to avoid chemical burns.
● DO NOT place the battery in the reach of children.
● When the device is powered off and the RTC battery is
full, the time settings can be kept for
6 months.
● In the first use, charge the device for more than 2.5
hours in the power-off status.
● The battery voltage is 3.85 V, and the battery capacity
is 2100 mAh.
● The battery is certified by UL2054.
Maintenance
● If the product does not work properly, please contact
your dealer or the nearest service center. We shall not
assume any responsibility for problems caused by
unauthorized repair or maintenance.
● A few device components (e.g., electrolytic capacitor)
require regular replacement. The average lifespan
varies, so periodic checking is recommended. Contact
your dealer for details.
● Wipe the device gently with a clean cloth and a small
quantity of ethanol, if necessary.
● If the equipment is used in a manner not specified by
the manufacturer, the protection provided by the
device may be impaired.
● We recommend you send the device back for
calibration once a year, and please contact the local
dealer for the information on maintenance points.
Using Environment
● DO NOT expose the device to extremely hot, cold,
dusty, corrosive, saline-alkali, or damp environments.
Make sure the running environment meets the
requirement of the device. The operating temperature
shall be -10 °C to 50 °C (14 °F to 122 °F), and the
operating humidity shall be 95% or less.
● This device can only be safely used in the region below
2000 meters above the sea level.
● Place the device in a dry and well-ventilated
environment.
● DO NOT expose the device to high electromagnetic
radiation or dusty environments.
● DO NOT aim the lens at the high intensity source like
laser.
● When any laser equipment is in use, make sure that
the device lens is not exposed to the laser beam, or it
may burn out.
● The device is suitable for indoor and outdoor uses, but
do not expose it in wet conditions.
● The level of protection is IP 54.
● The pollution degree is 2.
Technical Support
● The https://www.hikmicrotech.com portal will help
you as a HIKMICRO customer to get the most out of
your HIKMICRO products. The portal gives you access
to our support team, software and documentation,
service contacts, etc.
Emergency
● If smoke, odor, or noise arises from the device,
immediately turn off the power, unplug the power
cable, and contact the service center.
To Next Page
Loading...
Need help?
General
