This mode is suitable for moving objects. In this mode, device automatically adjusts
parameters according to the distance to objects, so as to ensure temperature
measurement accuracy.
Fixed Distance
This mode is suitable for
xed objects or objects moving in a very small area.
Optical Transmissivity
Set the optical transmissivity of external optical material (e.g.: germanium window) to
improve the temperature measuring accuracy. This parameter varies according to
different camera models.
Calibration
Coefcient
Check to enable it and set the value of calibration coefcient to get the temperature
of the external window or optical material automatically. The setting range is 0 to 30.
This parameter varies according to different camera models.
Note
You can get the setting value from SDK software.
External Optics/Window Correction
Set the temperature of the external window or optical material (e.g.: germanium
window) to correct the measured temperature. This parameter varies according to
different camera models.
Version
View the version of current algorithm.
Calibration File Version
View the version of calibration
le.
Alarm Interval
Set the alarm interval between two alarms.
4.
Go to Temperature Measurement > Advanced Settings > Algorithm Filter to lter false
alarm.
Reect Light Filter
Enable this function if there is strong reected light from sun, or it may cause false
alarm. The
lter sensitivity can be adjusted.
Forklift Filter
Enable this function when there are forklifts or high temperature moving objects, or it
may cause false alarm. You can select the lter level to lter out different kinds of
objects and set the ltering temperature.
Low
In this level, it only
lters the complete forklift.
Thermal & Optical Bi-spectrum Network Camera User Manual
55
To Next Page
Loading...
