11 ADD ANALOG CAMERAS
T Adding Analog Cameras
1. Connect analog camera(s) to the “Video In” BNC connectors.
T Adding Analog PoC Cameras
PoC cameras do not require camera power to produce an image on the DVR as they are powered
over-the-coax upon connection.
T Enabling Analog Cameras
2. Analog cameras are enabled by default; no further action is required.
12 VIEW LIVE VIDEO
Live View displays real-time video.
13 SET UP RECORDING
The system defaults to record video continuously at 8 fps, or at 15 fps when motion is detected.
T Recording Schedule
Default is to record continuously every day. Do the following to change the recording schedule:
1. Go to MENU > RECORDING CONFIGURATION > SCHEDULE.
2. Choose CONTINUOUS or EVENT/(MOTION DETECTION) under the Type pull-down menu.
3. Use cursor to select (days will turn blue [continuous] or yellow [event/motion detect]) or deselect
(days will turn gray [off]) the calendar days you wish to record.
4. Apply time settings as desired.
5. Press APPLY.
camera’s record and alarm status.
• Alarm (video loss, tampering, motion detection,
sensor alarm, or VCA alarm)
• Record (manual record, continuous record, motion
detection, alarm, or VCA triggered record)
• Event/Exception (event and exception information
appears at lower-left corner of screen)
To Next Page
Loading...
Need help?
General