28
User Manual
• If a vertical and horizontal frequency-select mode exists, select 60Hz (vertical)
and 31.5KHz (horizontal). In some cases, abnormal signals (such as stripes)
might appear on the screen when the PC power is turned o (or if the PC is
disconnected). If so, press the [INPUT] button to enter the video mode. Also,
make sure that the PC is connected.
• When horizontal synchronous signals seem irregular in RGB mode, check PC
power saving mode or cable connections.
• The display settings table complies to the IBM/VESA standards, and based on the
analog input.
• The DVI support mode is regarded as same to the PC support mode.
• The best timing for the vertical frequency to each mode is 60Hz.
To Next Page
Loading...
