HIKVISION DS-K1T343EFX User Manual

Figure 10-2 Display the Selected Person(s) and Access Point(s)
8.
Aer adding the access groups, you need to apply them to the access control device to take
eect.
1) Select the access group(s) to apply to the access control device.
2) Click Apply All to Devices start applying all the selected access group(s) to the access control
device or door
staon.
3) Click Apply All to Devices or Apply Changes to Devices.
Apply All to Devices
This
operaon will clear all the existed access groups of the selected devices and then
apply the new access group to the device.
Apply Changes to Devices
This operaon will not clear the existed access groups of the selected devices and only
apply the changed part of the selected access group(s) to the device(s).
4) View the applying status in the Status column or click Applying Status to view all the applied
access group(s).
Note
You can check Display Failure Only to lter the applying results.
The selected persons in the applied access groups will have the authorizaon to enter/exit the
selected doors/door
staons with their linked card(s) or ngerprints.
9.
Oponal: Click to edit the access group if necessary.
DS-K1T343 Series Face Recognion Terminal User Manual
140

HIKVISION DS-K1T343EFX Specifications

General

Brand	HIKVISION
Model	DS-K1T343EFX
Category	Touch terminals
Language	English