Access Control Terminal·User Manual
109
4. Click Add and select the cards to add as first card for the door and click
the OK button.
5. Click Save and then click the Apply button to take effect of the new
settings.
Anti-Passing Back
Purpose:
In this mode, you can only pass the access control system according to the
specified path.
Either the anti-passing back or multi-door interlocking can be configured
for an access controller at the same time.
Setting the Path of Swiping Card (Card Reader Order)
Steps:
1. Click Anti-passing Back and select an access control point.
2. You can set the name for the controller and select the card reader as the
beginning of the path.
3. In the list, click the text filed of Card Reader Afterward and select the
linked card readers.
Example: If you select Reader In_01 as the beginning, and select Reader
In_02, Reader Out_04 as the linked card readers. Then you can only get
through the access control system by swiping the card in the order as
Reader In_01, Reader In_02 and Reader Out_04.
To Next Page
Loading...
