Access Control Terminal·User Manual
41
2. Click the button to delete the selected device(s).
3. Click OK button in the popup confirmation dialog to finish deleting.
Bulk Time Synchronization
Steps:
1. In the device list, select a device by clicking it, or select multiple devices by
pressing Ctrl button on your keyboard and clicking them one by one.
2. Click the Bulk Time Adjustment button to start time synchronization.
A message box will pop up on the lower-right corner of the screen when
the time synchronization is compeleted.
Status
In the device list, you can click Status button to enter view the status.
1) Door Status: The status of the connected door.
2) Host Status: The status of the host, including Storage Battery Power
Voltage, Device Power Supply Status, and Host Anti-Tamper Status.
3) Card Reader Status: The status of card reader.
4) Alarm Input Status: The alarm input status of each port.
5) Alarm Output Status: The alarm output status of each port.
6) Event Sensor Status: The event status of each port.
Remote Configuration
In the device list, you can click Remote Configuration button to enter the
remote configuration interface. On this this interface, you can set the access
parameters, enable the face detection function, and so on.
To Next Page
Loading...
