Note:
1. 【Tag】here means short swiping (swipe time ≤ 3 s).
2. In relay page: Use , and # key to select the relay number, and press the to
confirm.
3. In area page: Use , and # key to select the area number, and press the , or
to confirm.
4. The password operation instructions mentioned above will first display all system faults and all
zone faults of the current control panel. You need to confirm faults by the # key, and then
perform the function of the next command (except for the query system fault command. After
you confirm the fault, the command will end).
5. Arming process:
When the control panel starts the arming process, the keypad supports three stages of the
arming process, including arming waiting, fault confirmation, and exit delay.
(1) Arming waiting stage: the keypad displays "Arming waiting".
(2) Fault confirmation stage: The keypad displays all system faults and operating area zone
faults. If it is an away arming operation, confirm with the away arm key; if it is a stay arming
operation, confirm with the stay arm key, and use the disarm key to cancel the fault.
(3) Exit delay stage: the keypad displays "Exit delay xxx s ", and the buzzer counts down.
Note: It only appears when the zone is the delay zone. Otherwise, the keypad displays the
arming result.
Skip the arming delay through the arm key.
Note: For away arming operations, this operation is also away arming; and for stay arming
operations, then this operation is also stay arming.
Cancel the arming through the disarm key.
Result:
Success: The corresponding arming indicator lights for 5 s and then lights off, and the voice
prompts the operation is successful.
To Next Page
Loading...
