adapter overload may cause over-heating or a fire
hazard.
If the product does not work properly, please contact
your dealer or the nearest service center. We shall
not assume any responsibility for problems caused by
unauthorized repair or maintenance.
Please use a soft and dry cloth to clean the interior
and exterior surfaces. Do not use alkaline detergents.
When any laser equipment is in use, make sure that
the device lens is not exposed to the laser beam, or it
may burn out.
DO NOT aim the lens at the sun or any other bright
light.
To avoid heat accumulation, good ventilation is
required for a proper operating environment.
DO NOT expose the device to extremely hot, cold,
dusty, corrosive, saline-alkali, or damp environments.
For temperature and humidity requirements, see
device specification.
DO NOT expose the device to high electromagnetic
radiation.
If smoke, odor, or noise arises from the device,
immediately turn off the power, unplug the power
cable, and contact the service center.
To Next Page
Loading...
