What to do if my HILL PUMPS EC-3000 Air Compressor is leaking and depressurizes?
If your HILL PUMPS Air Compressor is leaking or depressurizes without opening the bleed screw, it could be due to a worn quick release fitting or seal failure. Replace the quick release fitting. Use a leak detector to find the source of the leak.
Why is my HILL PUMPS Air Compressor no longer making pressure?
If your HILL PUMPS Air Compressor is no longer making pressure, or is making it very slowly, the ball valve in the compressor may have deteriorated. Replace the ball valve.
What to do if my HILL PUMPS EC-3000 stalls at higher pressures?
If your HILL PUMPS Air Compressor stalls at higher pressures, it could be due to a deteriorated ball valve or an issue with the top stage valve. You can clean the top stage valve, replace the piston O-ring, or replace the ball valve.
What to do if HILL PUMPS EC-3000 Air Compressor has loud bang and starts leaking?
If your HILL PUMPS Air Compressor experiences a loud bang and starts leaking, it's likely due to burst disc failure. Replace the burst disc.
Check and top up crank oil to the red dot on the sight glass.
Fill the lubricant reservoir up to the blue line with silicone oil.
Connect the filling probe to the hose and cylinder, ensure bleed screw is closed, and insert the power cable.
Switch on, confirm lube check, set target pressure, and select measurement units (BAR/PSI/MPa).
Start, pause, resume, or abort the filling process, and confirm when the target pressure is reached.
Depressurise the compressor after filling and follow safety warnings for operation.
Check power cable, switch, and fuse if the compressor does not start.
Address pressure loss from relief valve or cylinder pressure discrepancies.
Change crank oil and silicone oil every 50 running hours or annually.
General| Brand | HILL PUMPS |
|---|---|
| Model | EC-3000 |
| Category | Air Compressor |
| Language | English |
To Next Page
