To Next PageTo Next Page
Need help?Do you have a question about the Hilleberg Akto and is the answer not in the manual?
General| Season | 4-season |
|---|---|
| Weight | 1.7 kg |
| Inner Height | 90 cm |
| Inner Tent Area | 1.7 m² |
| Vestibule Area | 0.8 m² |
| Outer Tent Fabric | Kerlon 1200 |
| Capacity | 1 person |
| Packed Weight | 1.7 kg |
| Inner Tent Fabric | 30D Ripstop Nylon |
| Outer Tent Hydrostatic Head | 5000 mm |
| Pole Material | DAC Featherlite NSL |
| Inner Tent Material | 30D Ripstop Nylon |
| Doors | 1 |
| Poles | 1 x 9 mm |
| Floor Material | 70D Nylon |
| Type | Tunnel Tent |
Illustrations showing tent dimensions in inches and centimeters.
Contact details for Hilleberg offices in Europe and outside Europe.
Lists the items included with the Akto Mesh Inner Tent, including pole holder.
Explains how the Mesh Inner Tent can be used with a standard Akto tent.
Instructions on drying, cleaning, and storing the tent to prevent damage.
Advice to pitch the tent in shade to protect fabric from UV damage.
Connects the pole holder ring to the elastic loop on the tent's back wall.
Connects guy lines to the four raised corners of the tent.
Details how to thread and tighten guy lines using line runners.
Select an even, level, and wind-protected spot for pitching the tent.
Instructions on inserting pegs at a 45° angle and using tools if needed.
Using a shallower angle is better than leaving pegs sticking up.
Unfold and thread the pole through the tent's elastic loops.
Seat the pole ends securely in the back and front pole holders.
Pull up red cord, wrap around pole, and peg down the front pole holder.
Extend and peg out corner guy lines as far as possible.
Lay the Tarp 10 over the Mesh Inner Tent and loosely peg guy lines.
Use trekking poles or trees to create a ridge for the tarp above the tent.
Covers material and manufacturing defects; varies by country.
Excludes normal wear, UV damage, accidents, and improper care.
Repairs not covered by warranty are available at a reasonable rate.
