6 7
20.09.2021 20.09.2021
PLEN
b) Keep unused devices out of the reach of children
and anyone not familiar with the device or these
instructions. Devices are dangerous in the hands of
inexperienced users.
c) Keep the device in good working order. Before each
use, check for general damage or damage to moving
parts (cracks in parts and components or any other
device). If damaged, have the device repaired before
use.
d) Keep the device out of the reach of children.
e) Repair and maintenance of the device should be
spare parts. This will ensure a safe use of the device.
f) To ensure the designed operational integrity of the
device, do not remove factory installed covers or
loosen any screws.
g) Avoid situations where the device is overloaded
during operation. This can cause overheating of the
device.
h) Do not touch moving parts or accessories unless the
device has been disconnected from the power supply.
i) Do not leave the switched on device unattended.
build-up.
k) The vibration emission value may change when the
device is used in other environmental conditions.
l) The device is not a toy. Cleaning and maintenance
must not be performed by children without adult
supervision.
m) It is forbidden to tamper with the device in order to
change its parameters or construction.
o) Do not use the device in closed rooms and buildings!
p) Do not operate the device on slippery ground, at
night, during fog, thunderstorms, strong winds or
vision and balance.
could become an obstacle during operation.
r) Before starting work, check that the device has been
assembled correctly and is undamaged. Do not use
the device if it has visible signs of wear.
s) Some screws may become loose as a result of the
vibrations generated during use. Check their condition
and tighten them before each use.
t) The device is not designed to cut all materials. Work
only with those indicated by the manufacturer.
the device and then move it to the target spot paying
special attention to the blade.
running.
w) DANGER TO LIFE! Be careful of high voltage lines
when working with the device.
x) If the device encounters an obstacle during operation,
y) Do not start the engine or increase the speed unless
you intend to use the device.
z) Be extremely careful when cutting branches: angle the
blade of the device so that the branch does not fall on
aa) If the blade becomes bent, do not straighten it by
hand!
OGRODOWEGO
wybuchem.
ATTENTION! Despite the safe design of the device
and its protective features, and despite the use of
additional elements protecting the operator, there is
device. Stay alert and use common sense when using
the device.
PAMIĘTAĆ!
UWAGA!
higieny pracy.
WARNINGS CONCERNING WORKS WITH FLAMMABLE
MATERIALS:
1. The device engine is designed for mixed fuel:
Mixing gasoline and oils other than recommended
may damage seals, hoses and tanks.
heat (such as a boiler, oven), electrical discharges,
welding sparks that may ignite the fuel. Smoking near
the fuel tanks is prohibited.
3. Before refuelling, ensure that the engine is switched
4. Try not to spill fuel. If it happens, carefully wipe spilled
the tank carefully.
7. Empty the fuel tank before transport.
ostrzegawczy).
UWAGA
zamoczeniem.
10m
samodzielnie!
).
przestrzeni.
To Next Page
Loading...