Hilti HIT-HY 200 HIT-Z User Manual

page 1 February 2014
Product Data Sheet
HIT-HY 200
with HIT-Z
Basic loading data (for a single anchor)
All data in this section applies to
■ Correct setting (See setting instruction)
■ No edge distance and spacing inuence
■ Steel failure
■ Base material thickness, as specied in the table
■ Embedment depth, as specied in the table
■ One anchor material, as specied in the tables
■ Non cracked concrete f
c,cyl
= 32 MPa
■ Temperate range I (min. base material temperature -40°C, max.
long term/short term base material temperature: +24°C/40°C)
■ Installation temperature range -10°C to +40°C
Embedment depth and base material thickness for the basic loading data
Recommended loads
Anchor size M8 M10 M12 M16 M20
Typical embedment depth h
ef
[mm] 80 90 110 145 180
Base material thickness h [mm] 140 150 170 245 280
Recommended loads
Anchor HIT-Z
Anchor size M8 M10 M12 M16 M20
Tensile N
rec
[kN] 11.4 18.1 25.9 45.7 69.5
Shear V
rec
[kN] 6.9 10.9 15.4 27.4 41.7
Note: For varied embedment depths please contact your local Hilti engineer for further details.
Hilti HIT-HY 200 with HIT-Z
Injection Mortar System Benefits
■ no cleaning required: zero
succeptability to borehole cleaning
conditions with dry and water
saturated concrete base material
■
maximum load performance in
cracked concrete and uncracked
concrete
■
suitable for cracked and non-cracked
concrete C 20/25 to C 50/60
■
suitable for use with diamond cored
holes in non-cracked or cracked
concrete with no load reductions
Hilti HIT-HY 200-R
500 ml foil pack
(also available as 330 ml
foil pack)
Static mixer
HIT-Z
HIT-Z-R rod
CE
conformity
European
Technical
Approval
Concrete
A4
316
Corrosion
resistance
Tensile
zone
PROFIS
anchor design
software
No cleaning
required for
approved
loads
Seismic
Diamond
drilled
holes

Hilti HIT-HY 200 HIT-Z Specifications

General

Brand	Hilti
Model	HIT-HY 200 HIT-Z
Category	Laboratory Equipment
Language	English

Summary

Product Benefits

Basic Loading Data

Approvals and Certificates

Working Time and Curing Time

Setting Details

Materials and Anchor Properties

Anchor Dimensions

Installation Equipment

Setting Instructions - Borehole Preparation

Bore Hole Drilling

Describes pre-setting and through-setting drilling methods using hammer drill or diamond coring.

Bore Hole Cleaning

Details cleaning requirements for hammer drilled and wet-drilled diamond cored boreholes.

Check Setting Depth and Compress Dust

Instructions for checking embedment depth and compressing drill dust in the borehole.

Setting Instructions - Injection and Installation

Injection Preparation

Instructions on attaching mixing nozzle, checking foil packs, and dispenser usage.

Inject Adhesive

Guidance on injecting adhesive into the borehole, filling levels, and depressurizing dispenser.

Overhead Installation

Details on using extensions and piston plugs for overhead injection.

Setting the Element

Steps to set the anchor element, verify fill, and apply torque for loading.