18 English 2004955
*2004955*
2. If the following equipment exists, also take this action:
PSA 81
▶ Press the catch together.
▶ Remove the battery.
Remove the battery only when the tool is switched off. Data may otherwise be lost.
3. If the following equipment exists, also take this action:
PSA 82
▶ Press the spring catch in.
▶ Remove the battery.
The battery can be exchanged while the tool is in operation. The built-in backup battery is
capable of powering the tool for approx. 5 minutes.
4. If the following equipment exists, also take this action:
PSA 83
▶ Push the small slider on the back away from the battery compartment.
▶ Push the large slider toward the small slider.
▶ The battery is lifted.
▶ Remove the battery.
5.3 Charging the battery 4, 6, 5
1. If the following equipment exists, also take this action:
PSA 80
▶ Make sure the system to be charged is standing securely.
▶
Remove the battery. 17
▶ Connect the AC adapter to the charger.
▶ Plug the country-specific supply cord into the AC adapter.
▶ 1 LED lights green.
▶ Insert the battery in the charger.
▶ 1 LED lights red.
▶ The battery is charging.
Charge the battery for at least 14 hours before using it for the first time.
▶ When the battery is fully charged, disconnect the battery from the charger.
▶
Insert the battery in the tool. 17
2. If the following equipment exists, also take this action:
PSA 81
▶ Make sure the system to be charged is standing securely.
▶
Remove the battery. 17
▶ Connect the PUA 81 AC adapter to the battery.
▶
The battery is charging
Charge the battery for at least 2 hours before using it for the first time.
Alternatively, you can use the motor vehicle power adapter to charge the PUA 82 battery.
▶ Press the button on the top of the battery.
▶ Charge status is displayed
▶
Insert the battery in the tool. 17
To Next Page
Loading...
