What to do if 1 LED flashes on my Hilti SL 2-A12 Work Light and it doesn't work?
If 1 LED flashes and your Hilti Work Light isn't working, it could be due to a discharged battery. Try replacing the battery and charging the empty one. Alternatively, the battery might be too hot or too cold. In this case, allow the battery to gradually cool down or warm up to room temperature.
Why doesn't the battery engage with a double click on my Hilti Work Light?
If the battery isn't engaging with an audible double click on your Hilti Work Light, the retaining lugs on the battery might be dirty. Clean the retaining lugs and then push the battery in until it engages properly.
General| Battery Type | Li-ion |
|---|---|
| Light Source | LED |
| Battery Voltage | 12 V |
| Beam Angle | 120 degrees |
| Color Temperature | 5000 K |
| Protection Class | IP20 |
| Light Output | 2000 lumens |
| Luminous Flux | 2000 lm |
Provides guidance on reading and understanding the operating instructions for safe product use.
Details the meaning of warning symbols, signal words (DANGER, WARNING, CAUTION), and symbols used within the documentation.
Emphasizes reading all instructions to prevent electric shock, fire, and serious injury.
Provides guidelines for safe operation, including product condition and avoiding specific hazards.
Provides guidelines for safe handling, charging, and disposal of Li-ion batteries.
Illustrates and labels the key components of the SL 2-A12 and SL 2-A22 cordless lamps.
Specifies the product's purpose as an illumination device for jobsites and its environmental limitations.
Explains how to interpret the LED indicators to check the Li-ion battery's charge level.
Details how to use the 3-mode switch to adjust the lamp's brightness or turn it off.
Presents technical specifications for SL 2-A12 and SL 2-A22, including voltage, brightness, and weight.
Lists operating, storage, and charging temperature parameters for the 10.8V battery.
Lists operating, storage, and charging temperature parameters for the 21.6V battery.
Outlines essential safety precautions before product use, including switching off and removing the battery.
Provides instructions and safety warnings for securely inserting the battery into the device.
Details the procedure for safely detaching the battery from the product.
Explains how to pull out the hook and pivot the lamp head upwards for positioning.
Provides instructions and warnings for adjusting the lamp head's direction and position.
Describes the steps to turn on the lamp by positioning the head and selecting a mode.
Provides instructions for cleaning the tool and Li-ion batteries, and performing regular maintenance checks.
Details safety precautions for transporting and storing cordless tools with batteries removed.
Provides guidelines for storing tools and batteries safely, emphasizing cool, dry, and inaccessible locations.
Lists common problems with possible causes and recommended actions for the device.
Provides instructions for proper disposal of batteries and electronic equipment, avoiding household waste.
To Next Page
