24 25
2.3.2 Reed contacts and volumetric detectors
ATTENTION!
The PROTEC3 doesn’t allow the connection of the ‘switch’ contacts for rolling
shutters type C778 directly on the terminal boards becouse this central unit hasn’t got
an impulse counter.
Use the SCHSW impulse counter board to connect the ‘switch’ contact for rolling shutters
type C778, or use the ‘switch’ contact for rolling shutters C800 with integrated impulse counter
for the direct connection to this central unit.
InstallationPROTEC3 - User’s manual
Long wires
Long wires
Short wires
Short wires
In series to
the 24h line
4S
4S
C451
C401/P
2B4
PG12
Phone
line
In series to
the 24h line
2.3.3 Telephone dialer / Antitearing protection tamper
TD81
2B4
ANTITEARING PROTECTION TAMPER
screw +
anchor
ANTITEARING
TAMPER
2 screw
for fixing
on base
PROTEC series
Plastic
support
6mm hole for antitearing tamper
! Perform a 6mm hole and insert the plug supplied. .
! Tighten the screw until the boss useful. It will
activate the tamper on the back of the central series
PROTEC
Installation tamper on PROTEC base
! Insert into the hole in the plastic support provided.
! Plug the cable to the card.
! Secure with 2 screws the tamper base of
the plant, making sure that the tamper spring going
to fit into the plastic base.
Connecting to tamper central
! The tamper should be connected to the terminal on
the 24H of the plant, using the supplied cable.
securitysecurity
To Next Page
Loading...
