Hino 358 - Inspect the DPR Filter; Inspect the Exhaust Gas Temperature Sensor (Burner Inlet) Connector

ENGINE CONTROL SYSTEM (J08E) 4–1143
1. Remove the DPR filter and check if there is no soot, damages or
other abnormalities at its end.
2. Check for proof of a forceful removal of the DPR filter.
NOYES
1. Check the connection of exhaust gas temperature sensor connec-
tor (burner inlet) (Looseness and poor contact).
NOYES
8
Inspect the DPR filter
Damage
SAPH16F010300876
Soot leakage
SAPH16F010300877
Was any failure found?
Replace the DPR filter and the burner, and
clean the igniter.
Perform "After-inspection work" of INFOR-
MATION section.
Go to step 9.
9
Inspect the exhaust gas temperature sensor (burner inlet) connector
Was any failure found?
Connect securely.
Repair if needed.
Perform "After-inspection work" of INFOR-
MATION section.
Go to step 10.