MP-1681 MMi R3 All right @Hinston Electronics Co., Ltd
2.6. Lighting and PIR control
2.6.1. Press < > once to turn on or turn off the light on the bottom of the unit, when tune
on lamp and not to tune off again , it’s will automatic off for 120 minutes
2.6.2. Press and hold < > till “do” sound appear to tune PIR on , Press and hold < >
again and till “dodo” sound appear to tune off PIR
2.6.3.
Once tuned PI R on, the lamp will be au tom a tic tun e on for 30 seconds if any
human body move nearly , at the moment can press < > to turn off the lamp
2.7. Accessory
2.7.1. EU and US plug for using device on most world place
2.7.2. External antenna : when using device by internal battery , may need external FM antenna to
improve reception ,then need to :
Remove AC plug from device
Put an plug external antenna holder in to AC connector
Pay your attention!
When you put back plug to device, make sure listened a “click” sound
before connect to AC power
Don’t connect FM external wire antenna to any AC socket
2.8.
Rating
Warning!
1. Do not covering the ventilation
2. No naked flame sources, such as lighted candles, should be placed on the apparatus
3.
No objects filled with liquids, such as vases, shall be placed on the apparatus.
4. For indoor use only. The apparatus shall not be exposed to dripping or splashing. Do not use in wet
or high humidity areas, such as kitchen or bathroom
5.
The mains plug is used as the disconnect device, the disconnect devices shall remain readily
operable.
6. Do not open! No user replaceable parts inside, refer servicing to qualified service personnel
7.
Only use attachments/accessories specified by the manufacturer.
Disposal: All electrical and electronic products including batteries should be disposed
of separately from the municipal waste stream via designated collection facilities
appointed by the government or the local authorities
To Previous Page
Loading...