3.1 Voltage Measurement
23
1
2
3
4
5
6
7
8
9
10
5
Move the blinking cursor to the position shown.
Set the scaling unit to "V."
Move the blinking cursor to the position shown.
Enter the following:
A: +0.0000E+00 → +0.0000E+00
B: +1.0000E+01 → +1.5000E+02
❖
See Section 5.4 "Setting Scaling" (page 86) of Instruction Manual.
Upper limit value: 150 V, Lower limit value: 0 V
• Setting the scaling to correspond to the transducer conversion
ratio allows the measurement values to be read off directly.
• With the origin Posn setting at "0%" the range from 0 to 150 V
is displayed.
To Next Page
Loading...
