30
3.2 Temperature Measurement Using a Thermocouple (K)
Quick Start Manual
Unless the Store CH setting is on, it is not possible to make input
settings in the channel screen.
A digital filter can be used on analog channels to remove noise in
the input signals.
The longer the recording interval is, the larger the noise reduc-
tion effect becomes; this ensures highly accurate measurement
with little scatter.
Set the filter to 50Hz in areas where the supply frequency is
50Hz.
Set the recording period (Record Time) to "Cont: ON."
Move the blinking cursor to the position shown.
Select "Cont: ON."
Turn on the channel 1 (CH1) of the Store CH.
Move the blinking cursor to the position shown.
Turn on the channel 1, by putting a check mark in the CH1
box of Store CH.
Set the digital filter to "60 Hz."
Move the blinking cursor to the position shown.
Select "60 Hz."
To Next Page
Loading...
