3.2 Temperature Measurement Using a Thermocouple (K)
33
1
2
3
4
5
6
7
8
9
10
5
10. Press the key to start measurement.
11. Press the key twice to abandon measurement.
12. Monitor changes in temperature on the Waveform Screen.
See Section 6 "Waveform Screen" (page 99) of Instruction Manual.
Set the burn out detection (Burn Out) to "OFF."
Move the blinking cursor to the position shown.
Select "OFF."
Set the display position to "0%."
Move the blinking cursor to the position shown.
Select "0%."
Upper limit value: 100°C, Lower limit value: 0°C
To Next Page
Loading...
