Hioki 8420-51 - Page 43

3.3 Integrating the Pulse Output from a Power Meter
39
1
2
3
4
5
6
7
8
9
10
5
Set the recording period (Record Time) to "30 days."
Move the blinking cursor to the position shown.
Select "30 d."
Turn on the pulse channel 1 (P1) of the Store CH.
Unless the Store CH setting is on, it is not possible to make input
settings in the channel screen.
Move the blinking cursor to the position shown.
Turn on the pulse channel 1, by putting a check mark in the
P1 box of Store CH.
Set the automatic saving to "Binary (Real time)."
Move the blinking cursor to the position shown.
Select "Binary (Real)."